5iMX.com 我爱模型玩家论坛 ——专业遥控模型和无人机玩家论坛（玩模型就上我爱模型，创始于2003年）

标题: 我也发个云台吧,国外的,简单实用,大家可以自己造 [打印本页]

作者: considerwei 时间: 2008-8-1 10:50
标题: 我也发个云台吧,国外的,简单实用,大家可以自己造
http://www.rangevideo.***/index.php?main_page=product_info&cPath=47&products_id=132 把***换成com

作者: allegro 时间: 2008-8-1 11:09
这个论坛很恶心

作者: Suzhoujimmy 时间: 2008-8-1 12:30

原帖由 allegro 于 2008-8-1 11:09 发表
这个论坛很恶心

你说话好酷哟，来这儿找恶心的？你的爱好很特别哟。

作者: 归巢雁 时间: 2008-8-1 12:53
ri***是虾米？？？？

作者: jason_cx 时间: 2008-8-1 17:14
标题: 发上来就是了！看图说话
TS2-Pod kitStarting at: $40.00

Please Choose: Pan & TiltKX191( more powerful HS81 servo for pan) ( +$10.00 )
KX131/KX171
KX151

Add to Cart:

The EZ Pod kit is the best way to convert your stock Multiplex Twinstar 2 into an FPV airplane. No modification to the airplane is required. The TS2 Pod snaps into the stock canopy holders.

The kit is precisely laser cut from plywood. You can assemble the kit rapidly, in 15 minutes with superglue.

Camera and transmitter not included. Be sure to select your camera( KX131/KX171 or KX151) when ordering the EZ- Pod.
Purchase includes :
- Plywoord parts
- Pre-cut 1/16" SS rod (2)
- Dubro Dura-Collars 1/16" (4)
- Dubro EZ connector
- Rare Earth Magnet - Disc - D0.125 x T0.063 (10)
- M2x8 brass screws and nuts (4)
- 9 gram servo (2)
TS2 Assembly Instructions.
1. Pan and Tilt Assembly

Glue the two smaller pieces evenly to create a 2mm slot

Glue the top piece. Avoid getting glue in the middle slot.

Make sure there is no glue residue in the axle slot.

You may mount the camera to the assembly using double sided table.

Cut the servo tabs away fom ONE servo. This servo is used for tilt.

Glue the tilt servo to the previous assembly, as shown

Trim the servo arm to fit the 'Pan' base. Screw the servo arm to the pan base. Epoxy is recommended to reinforce the connection between the servo arm and pan base.